Blendtec 7 DESIGNER 725 Bedienungshandbuch PDF herunterladen (Seite 18)

3� BLENDER JAR IS DISHWASHER SAFE—TOP RACK ONLY!

4� Extreme temperatures damage the lower seal of the jar� We recommend handwashing

to prolong the life of the blender jar� We do not recommend the jar be used or

exposed to, temperatures above boiling (212°F, 100°C)�

SECTION 7: TROUBLESHOOTING

While we don’t expect you to have any problems with your blender, sometimes

failures do occur� Use the following guidelines to see if the problem is easily ﬁxed

or requires service�

7.1 BLENDER MOTOR WILL NOT TURN ON (NO POWER)

If the blender motor will not turn on, try the following:

1� Determine if the Power Button is lit� Absence of a lit Power Button indicates a

lack of power to the unit�

2� Make sure the blender is plugged in�

3� Check your house circuit breaker switch or fuse to make sure it is set to the

ON position�

4� Press the Power Button located on the upper right hand side of the touch area�

5� Unplug the power cord from the wall receptacle, wait 5 seconds, then plug power

cord back in�

7.2 ERROR MESSAGES ON DISPLAY

If this icon appears on your blender, it indicates that the motor is overheating� The

blender has been disabled until the unit cools to operating temperatures� Turn off

and unplug the unit� Allow it to cool for at least 20 minutes, then plug it back into

check if the icon is still visible� If the icon does not disappear after 20 minutes or

more of cooling time, please call your Blendtec Service Agent�

If this icon appears on your blender it indicates that more than one touch sensor

on the blender has been touched� This icon should only appear as long as the

multiple sensor areas are being touched� If this icon remains on when no one is

touching the touch area unplug and re-plug in the blender� If the problem persists

please contact your Blendtec Service Agent�

If this icon appears on your blender, please turn off and unplug the unit� Check

the blender jar for blockage and clear if necessary� Plug in the unit and turn the

blender on again� If the icon is still visible on your blender, contact your Blendtec

Service Agent�

If this message appears on the LED information center it indicates there has been

an error� There are error messages from E-01 through E-06� If any of these errors

appear, press the stop button to clear the message� If the error message

reappears please contact your Blendtec Service Agent�

1 2 ... 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Blendtec 7 DESIGNER 725 Bedienungshandbuch Seite 18